Search:

Oh thank you so much for that. Problem solved again, thanks to you Mike. I'm very grateful :)

Please help me. Further to my post of 2 days ago (When I publish, instead of my website appearing, it's all just code, Please help.) After fixing my site (with lots of help) and uploading it to the...

Hello Mike. I can't thank you enough. I have finally, successfully uploaded the site exactly as it should look by following your instructions. It's in the temp site I created www.dianak.co.nz so now...

It doesn't go up on the web like that. If I publish it to the web it appears as it did yesterday when I first put it up for you to see. All messed up.

The code only, shows only when I 'preview'...

Hi Laurence, thank you. I have done that. I copied and pasted it into a text frame. It's at www.dianak.co.nz The actual web site (without the needed changes for the new owner) is at...

Good morning Laurence, my problems just seem to be worsening now. I fixed everything so in its working mode the site looks fine. I preview it and get only code appearing. I publish it locally and...

Darn it. On second look this site is very wrong. Master borders on pages that should have zero margins, basic bits are the wrong sizes etc. I have (in the last half hour) been into Fusion and changed...

Laurence. Thank you very much for suggesting I make a temp site for it to go on. If you've seen it yet, www.dianak.co.nz you will see (as I just have) that it appears to have uploaded ok. There are...

I've just made www.dianak.co.nz and although I've uploaded the site, it's not showing for some reason. Could be it'll take a little while as I've just registered the domain name as well. I didn't...

oh thank you - I will try to and let you know. Many thanks :)

I built this site about 2.5 years ago in Fusion 10, I think I've done minor changes a couple of times since then without incident. This time I had to simply change a tiny amount of text on each page...