Results 1 to 3 of 3

Thread: NetObjects 10 won't install on Windows 7

  1. #1
    Junior Member
    Join Date
    May 2011
    Posts
    2

    Default NetObjects 10 won't install on Windows 7

    Can someone help me figure out how to get version 10 to install? I recently upgraded my laptop which has Windows 7 on it. I was able to install version 10 and it appeared to install. I went to open it a couple of days later and it wouldn't load. I assumed I'd done something wrong in the installation and uninstalled it. I now can not get it to install. The launch file won't launch, I have to manually launch it and it won't let me select the NetObjects Fusion 10 option. If I launch the setup file directly for Fusion 10 it says this version of my software isn't compatible with my operating system. So, I can't even do the fix which is listed at the top of this forum to make the program run since I can't get it to install.

  2. #2
    Senior Member barbara0701's Avatar
    Join Date
    Apr 2010
    Location
    Germany
    Posts
    1,184

    Default

    Hello aalmos,

    have a look at this thread:

    http://forums.netobjects.com/showthr...indows-Vista-7

    Once you have followed the instructions for installing, you should open your project from a template, if possible. I hope you have saved your website as a template. More infos on this topic:

    http://www.gotfusion.com/tutorials/tut.cfm?itemID=16

  3. #3
    Junior Member
    Join Date
    May 2011
    Posts
    2

    Default

    Thank you for the link. I had already found that. I tried to reinstall a couple of days later and it installed just fine - I then implemented the fix you suggested so it will run. Not sure why it wouldn't install that one day.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •