-
Junior Member
Fusion 2013 stopped working
I had an old version of NetObjects Fusion on an old computer that failed. Bought a new computer and tried NetObjects Fusion Essentials. This was not suitable so bought NetObjects Fusion 2013 upgrade. This worked OK until today when I uninstalled NetObjects Fusion Essentials. I am now getting a message that the serial number is invalid and that I should reinstall. I have tried this but get message about 2013 already being on the computer. I have the backup disk and the serial number. What should I do?
-
Senior Member
Uninstall 2013 and then reinstall from the disk. Make sure you copy the folder where you keep your sites (User Sites is the default) to a safe location before uninstalling. The user sites folder shouldn't be affected, but it's always best to be sure.
-
Junior Member
Thanks Franko
That worked a treat. Happy Christmas and all the best for 2015.
Alistair
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules