Unable to update after publishing

[giovannismith]

Created my first sample web page and published it in NetObjects Fusion 11. It published OK the first time. However without changing any parameters, I now cannot update and even the "test connection" now fails.
Tried to FTP to the site, username and password doesn't seem to work. (Note: double and triple checked username/password so that's not the problem)
Decided to use another PC on a different network and "poof" everything back to normal, I could FTP to my site. I then updated the web page with NetObjects Fusion 11 from this second PC and it published Ok.
However again, now on this second PC, without changing any parameters, I cannot now FTP into the site again and even the "test connection" in NetObjects Fusion 11 fails.
Tried disabling Firewall & Anti-virus with no success.
Hosting Company says there is no problem on their end.
The common factor seems to be NetObjects Fusion, but unsure
Any Advice would be greatly appreciated, Asyou can see, new at this!

[gotFusion]

The first thing to try is to toggle passive mode in publish view settings (if it is checked, uncheck, if unchecked, then check)

Click the publish view icon, then click the settings icon, see screenshot for settings location

[giovannismith]

Hi Mike
Sorted out my problem. Web hosting co was blocking my IP address.
Thanks for assisting
Giovanni

[gotFusion]

Hi Mike
Sorted out my problem. Web hosting co was blocking my IP address.
Thanks for assisting
Giovanni

That was rather nice of them (NOT)

I hope you return the favor